Turntables for In-Plant LiftsCATALOG PDF 
320KB
 |
Flush-Mount Turntable The built-in turntable is essentially flush to the table platform in a clean, uncluttered design. The turntable bearings and support are under the platform and do not substantially increase the lowered height over that of comparable lifts without turntables. The turntable sits only 3/16" higher than the surrounding platform and is rotationally locked when the lift is in the full down position. Flush Mount turntable lifts are available in standard Southworth Backsaver Lift capacities to 4000 lbs. Turntables are available in 2 sizes; 20" and 43" diameter and are fitted into a limited number of platform sizes. The 43" diameter model can even be pit mounted. |
 |
Mounted Turntables Virtually any standard Southworth lift can be furnished with a turntable. Turntables are mounted directly onto the lift platform and are available in a wide range of capacities, configurations, and bearing types. Southworth turntables may be placed directly on the floor or mounted on fixed height platforms. They are available in capacities up to 6,000 lbs. and sizes to 60" by 60" |
 |
Turntable Ring Turntables rings are low profile turntables that are fully supported by bearings around their entoire periphery. They may be mounted or simply placed on any stable surface that will support their loaded weight. This includes lift tables, fixed height platforms on floors. When used with lift tables or platforms, the turntable ring diameter must be less than the smallest dimension of the platform. The diameter is 43 5/8" and turntable rings are available in capacities to 4,400 lbs. |
 |
PalletPal Disc Turntables Low-profile design, less than 1" high, allows Palletpal Disc Turntables to accept a hand pallet jack. The turntable can be easily moved throughout the plant. The 43" diameter is ideally sized to handle most pallets. Available in capacities to 4,000 lbs. |